Miele PT 7137 WP Vario 커미셔닝, 프로그램 차트 및 설정 - 페이지 20
{카테고리_이름} Miele PT 7137 WP Vario에 대한 커미셔닝, 프로그램 차트 및 설정을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele PT 7137 WP Vario 28 페이지.
Miele PT 7137 WP Vario에 대해서도 마찬가지입니다: 설치 계획 (11 페이지)
페이지 인쇄
Settings
Time
First decide whether you want the
clock displayed as a 24 hour or 12
hour clock, or not to display it at all.
Then set the current time of day.
– 24 h clock or 12 h clock
Once the clock display has ben
selected, the time of day can be set.
To set the time (of day)
Use the multi-function selector to
select the current hour and confirm
your selection.
Use the multi-function selector to
select the current minutes and
confirm your selection.
– Time not displayed
If Delay start is activated, (see
Settings Delay start), then the timer
will only show the option Start in or
Finish in in hours/minutes.
Contrast
Brightness
There are ten different display contrast
and display brightness settings.
The bar chart shows you the setting.
– Factory default: medium
Standby
To save energy, the display goes out
after 10 minutes and the Start button
flashes slowly.
20
The display is switched on again by
touching the multi-function selector or
or one of the short-cut buttons, without
any effect on any programme that is
running.
– On
Standby comes on:
. . . if a programme is not selected.
. . . after the Start button has been
pressed in a programme that is
running.
. . . after the end of a programme.
– Not in current programme (factory
default setting)
Standby is switched on if no
programme selection is made after
the end of a programme.
– Off
The display remains on all the time.
Please note:
This setting results in increased
energy consumption.