Miele K 12820 SD edt 작동 및 설치 지침 - 페이지 37

{카테고리_이름} Miele K 12820 SD edt에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele K 12820 SD edt 44 페이지. Refrigerator with dynamiccooling
Miele K 12820 SD edt에 대해서도 마찬가지입니다: 운영 및 설치 매뉴얼 (48 페이지), 운영 및 설치 매뉴얼 (40 페이지), 작동 및 설치 지침 (44 페이지), 작동 및 설치 지침 (48 페이지)

페이지 인쇄

^ Take the door and guide the upper

door bush onto the upper hinge

pin k.

^ Pivot the door and place the hinge

pin e into the hinge plate d.

Important. Turn the hinge pin if

necessary, so that the notch is

pointing to the inside of the door and

the groove to the outside. The hinge

pin will then click into place.

^ With the help of another person,

carefully tip the appliance back and

screw in retaining screw c. Tighten it

with the spanner supplied.

^ Realign the door with the appliance

housing again if necessary using the

long slots in the lower hinge plate.

Then tighten the screws.

Changing the door hinging

Refitting the handle

Please make sure you follow the

instructions below carefully when

you refit the handle. The door seal

will be damaged if the handle is

fitted incorrectly.

^ Loosely attach the handle to the

opposite side of the door with the two

front screws b.

Mounting plate c must be positioned

on the side of the door so that when the

door is closed it is flush with the side of

the appliance.

If this is not the case,

^ Tighten both threaded pins a with a

suitable allen key until mounting plate

c lines up correctly.

^ Then tighten all 4 screws b.

^ Slide the side section of the handle

d into the guides on the mounting

plate until it clicks into place.