ABB ACS880-01 Series 사용자 설명서 - 페이지 6

{카테고리_이름} ABB ACS880-01 Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB ACS880-01 Series 18 페이지. Industrial drives
ABB ACS880-01 Series에 대해서도 마찬가지입니다: 설치 매뉴얼 (20 페이지), 빠른 설치 매뉴얼 (14 페이지), 매뉴얼 (16 페이지), 빠른 설치 및 시작 매뉴얼 (17 페이지)

페이지 인쇄

Basic start-up

1. Lay the democase on its back (so that the door is pointing up) and open the door.

2. Pull the demo out of the case using the lifting strap and the handle hole (on the

lower part of the demo.) Warning! The demo weighs approximately 25kg. Use of

proper lifting technique with a straight back is advised.

3. Take out the mains cord and Ethernet cable from the pocket at the back of the

demo.

4. Plug in the mains cord and Ethernet cable (to connections marked: mains cord,

IO-panel connection A and IO-panel connection B on the layout section.)

5. Check that the Input voltage switch (115V/230V) is set according to the supply

voltage.*

6. Check that the Drive Main Supply is switched on.

7. Switch on the demo using the mains switch.

8. You can toggle control between the control panel and the IO-panel with the

"Loc/Rem" –button on the control panel.

* For more information check "AC input (supply) connection" in the Technical data

section

Mechanical brake

The mechanical brake is intended for momentary impulse braking for load

demonstration purposes. The mechanical brake is not designed for continuous load

which might damage the transformer and the brake itself.

User's manual – ACS880 01 democase

ac.maher.co.ir