Dialogic D/4PCI 설치 및 교체 - 페이지 8

{카테고리_이름} Dialogic D/4PCI에 대한 설치 및 교체을 온라인으로 검색하거나 PDF를 다운로드하세요. Dialogic D/4PCI 19 페이지. Linecard
Dialogic D/4PCI에 대해서도 마찬가지입니다: 설치 및 교체 (18 페이지)

Dialogic D/4PCI Linecard Installation and Replacement

Connecting the D/4PCI to the Telephone System

With the D/4PCI linecard(s) installed in the platform, you can now cable the platform to the

telephone system. As described in "Assigning a Linecard Identification Number," the

OneBox telephony server assigns port numbers in ascending order based on the linecard

identification number. Therefore, the D/4PCI linecard to which you assigned the linecard

identification number 1 will be assigned port numbers 1–4, and the linecard to which you

assigned the linecard identification number 2 will be assigned port numbers 5–8 (as shown

in Figure 3). Keep this port number assignment scheme in mind when connecting each

D/4PCI linecard to the telephone system.

To cable Dialogic D/4PCI linecards to the telephone system:

• Plug the linecords (jacks) from the telephone system (switch) to the RJ-11 connectors

on the D/4PCI (refer to the port assignment diagram shown in Figure 3).

Note Country-specific linecord adapters may be required to connect the telephony

server to the local public telephone network. If these adapters are required and not

included with the linecards, please contact your technical service representative.

Linecard

ID# 1

ID# 2

Port 1

Port 5

Port 2

Port 6

Port 3

Port 7

Port 4

Port 8

Figure 3. D/4PCI linecard port assignments

R2B Copyright

Ericsson Enterprise AB 2001