AllPondSolutions WF-20000 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} AllPondSolutions WF-20000에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AllPondSolutions WF-20000 10 페이지. Floating fountain pump

To ensure your fountain pump is set up and running correctly, and to prevent any

accidental damage or injury, please read and follow the below instructions

carefully before using your product.

SAFETY

IMPORTANT!

Disconnect the mains electricity supply before attempting any

installation / maintenance of any kind. Do not attempt to modify this unit in

any way and only use the recommended parts for replacement.

The WF-20000 fountain pump should never be run dry as this will cause the

unit to overheat and cause permanent damage.

All connections must be earthed.

The power cord of this appliance cannot be replaced; if the cord is

damaged, the appliance should be discarded. Never cut the cord.

Do not connect to any voltage other than that stated.

Do not place in liquids other than water.

Do not use with water above 9 F or

Do not use with water below 39.2

Do not carry or pull the unit by its electrical cable.

Do not use this unit if it has a damaged cord, if it is malfunctioning or if it is

dropped or damaged in any manner

Do not attempt to modify this unit in any way. Only use attachments and the

recommended parts for replacement recommended by the manufacturer.

Before installing, maintaining or handling your equipment, or before placing

your hands in your pond, ensure that the unit is disconnected from the

electricity supply.

Always disconnect any electrical devices when not in use.

Carefully examine your fountain aeration pump after installation. Do not

connect the unit to the mains if there is water on any parts not intended to

be wet.

5°

35°

°F

or 4 .

°C