AQUAPHOR RO-101S 소유자 매뉴얼 - 페이지 4

{카테고리_이름} AQUAPHOR RO-101S에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AQUAPHOR RO-101S 20 페이지. Reverse osmosis system
AQUAPHOR RO-101S에 대해서도 마찬가지입니다: 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (16 페이지)

페이지 인쇄
AQUAPHOR RO-101S 소유자 매뉴얼
1. Operational parameters, Cont.
Table 1. The dependence of minimum necessary operating pressure of the water purifier from
mineralization.
Mineralization
mg/L, ppm
100.1
200.2
300.3
400.4
500.5
ATTENTION
The efficiency of RO depends on the incoming tap water mineralization and tap water pressure
(please see Table 1). The recommended operation of RO requires tap water pressure of at least
0.2 MPa (2 bar / 29.01 psi).
When tap water pressure is less than illustrated in the Table 1, it is highly recommended to
install a booster pump in order to obtain drainage ratio.

2. Safety instructions

Warning: RO must be applied to potable water only.
It is highly recommended that a water treatment specialist be hired to install and maintain this appliance.
When installing the appliance into a local water supply, it is recommended that you conduct a full water
analysis. If the water analysis does not correspond with the requirements, the life of the filtration and membrane
cartridges may be significantly reduced. In this case, it is recommended to use auxiliary water treatment sys-
tems (e.g. mechanical filter, de-ironing filter with, or alongside a water softener). Only use microbiological safe
water with your Reverse Osmosis system appliance.
Caution: Do not use water that is microbiologically unsafe or water of unknown quality without
adequate disinfection before or after using the appliance.
Caution: Reverse Osmosis water should not be run through copper tubing as the purity of the
water will leach copper and cause an objectionable taste in the water. Additionally, it will form
pinholes in the tubing. Be sure to follow any state or local regulations.
Caution: The Reverse Osmosis system is designed to be connected to cold water only. Never
run warm or hot water through your appliance.
4
gpg
MPa
5.8
0.2
11.7
0.25
17.5
0.3
23.4
0.4
29.2
0.6
Minimum pressure
bar
2
2.5
3
4
6
AQUAPHOR RO-101S, RO-102S
psi
29.01
36.26
43.51
58.02
87.02