AQUAPHOR RO-206S 운영 매뉴얼 - 페이지 7

{카테고리_이름} AQUAPHOR RO-206S에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AQUAPHOR RO-206S 17 페이지. Reverse osmosis system

페이지 인쇄

1. Specification Data

Installation of the treated water tap (Fig. 6)

• Drill a 12 mm hole in the sink (benchtop).

• Place the rubber gasket (2), the decorative plate

(3), the rubber gasket (4) on the threaded shank

of the tap (1) and insert the tap into the sink hole.

• Put the plastic (5) and the metal (6) lock washers

on the threaded shank from the bottom of the

benchtop and screw the fixing nut (7) until tight

(you can use a 14 mm pipe wrench).

• Insert the metal sleeve (8) into the blue tube (10),

and the tube into the threaded shank of the tap

(1) and tighten the clamping nut (9) until tight.

• Check that the tube (10) is tight. The tube should

not be pulled out using a force of 80-100 N.

ATTENTION! It is recommended to use the stand-

ard RO-206S tap for treated water. Using other

taps may result in humming and other unusual

sounds.

Installation of the drain clamp* (Fig. 7)

• It is recommended to install the clamp on the

sink drain upstream of the S-trap (the drain

clamp fits most drain pipes which are about

40 mm in diameter).

• Attach the part of the clamp with the fitting to

the pipe and find the optimal position of the

clamp and a hole for the tube.

• Drill a 7 mm hole in the pipe wall in the intended

place.

• Remove the cut round part from the gasket (1).

• Remove the protective film (2) from the gasket

(1). Attach the gasket (1) on the inside of the

clamp so that the hole in the gasket aligns with

the hole in the clamp fitting.

• Install the clamp on the pipe, aligning the hole

in the fitting with the drilled hole in the pipe,

and then tighten the bolts (3). The bolts should

be tightened evenly so that the two parts of

the clamp are parallel.

• Put the plastic nut on the JG drain tube so that

the tube extends from the other side of the nut

by at least 20 mm (Fig. 7b).

• Insert the tube into the drain clamp and screw

the nut onto the fitting.

Note. Push the JG tube deeper into the pipe if

you are disturbed by the sound of water coming

from the drain clamp.

* The manufacturer reserves the right to use connecting assemblies and taps of a similar design. If you have any questions,

please, contact the service department.

Fig. 6

Fig. 7a

Fig. 7b