Panasonic WVNS954 - NETWORK CAMERA 설치 매뉴얼 - 페이지 16
{카테고리_이름} Panasonic WVNS954 - NETWORK CAMERA에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic WVNS954 - NETWORK CAMERA 31 페이지. Ip video cameras
Panasonic WVNS954 - NETWORK CAMERA에 대해서도 마찬가지입니다: 사양 (2 페이지), 사용 설명서 (21 페이지), 브로셔 (2 페이지), 참조 (2 페이지), 참조 (2 페이지), 통합 참고 사항 (8 페이지), 사용 설명서 (21 페이지)
페이지 인쇄
Installations/connections
Installation
Before starting installation/connection, make sure that the power plug is not connected to an outlet.
Read the "Precautions for installation" section before starting installation/connection.( page 13)
Step 1
Remove the screw (M3 x 6) fixing the camera and the
base unit.
• Do not lose it since it is to be used to fix the cam-
era and the base unit again.
Step 2
Detach the base unit.
• Rotate the base unit to the direction as indicated
by the arrow mark as shown in the illustration, and
detach it.
Rotate
16
Fixing screw
Detach the dome
cover by pushing
upward after
loosening the
screws.
15°
Detach the base unit
after pushing it upward.
Step 3
Manufacture the camera and the decorative cover.
• It is necessary to fabricate the camera body and
the decorative cover to pull out the cables (power,
monitor out, LAN, alarm in/out, audio in/out) from
the side of the camera.
Refer to the following illustrations for how to fabri-
cate the camera body and the decorative cover.
[Fabricate the die-cast case of the camera]
* Mat a soft cloth when fabricating the die-cast body
of the camera body to prevent to scratch the dome
cover.
[Fabricate the decorative cover]
Bend and
remove it
using pliers,
etc.
Remove it using
a cutter, etc.