Panasonic AW-HS50 Series 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} Panasonic AW-HS50 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic AW-HS50 Series 6 페이지. Combining pinp
Panasonic AW-HS50 Series에 대해서도 마찬가지입니다: 매뉴얼 (20 페이지), 브로셔 및 사양 (4 페이지), 매뉴얼 (4 페이지), 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (4 페이지)

페이지 인쇄
Panasonic AW-HS50 Series 빠른 시작 매뉴얼
② Set the information for connection with AW-HS50.
Menu: (10) SYSTEM > [3] SW CTL => [Network]
③ Enable the link with AW-HS50
Menu: (9) SETUP > [2] SW LINK => [On]
When the above configuration of AW-HS50 and AW-RP50 is completed, "LINK" lamp on AW-HS50 Control Panel –
(Fig.4) lights up in green and the linked-up functions are ready for use.
(Figure 4: AW-HS50 Control Panel)
④ Set up the remote cameras to correspond to the video inputs on AW-HS50.
(On AW-RP50, SDI IN 1 – 4 are indicated as INPUT1 – 4, DVI-IN as INPUT5.)
According to this set-up, if one of the cameras that have been set up is selected using AW-RP50, AW-HS50
receives the information of selection.
Menu: (10) SYSTEM > [4] SW ASSIGN => 1. INPUT1 – 5. INPUT5 => [CAM1 – CAM100]
* For example, if a video output from the remote camera connected to AW-RP50 [CAM10] is sent into AW-HS50
INPUT3, when the above menu setting is set to "3. INPUT3 => [CAM10]", the image will be switched by
selecting this camera.
* Default: [NoAsign]
* Default: [Off]