HP 1420-16G 시작하기 매뉴얼 - 페이지 10
{카테고리_이름} HP 1420-16G에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP 1420-16G 23 페이지.
페이지 인쇄
Figure 7 Hole spacing
2.
Insert one wall anchor into each hole until the anchors are flush with the wall surface.
3.
Drive one screw into each wall anchor, and tighten the screws just enough to keep it secure in the
wall anchor.
Leave a minimum clearance of 1.5 mm (0.06 in) between the base of the screw head and the wall
anchor so the switch can hang on the screws securely.
Figure 8 Driving a screw into a wall anchor
4.
Align the two mounting holes in the switch chassis bottom with the two screws on the wall and
hang the switch.
Make sure the Ethernet ports are facing upwards or downwards and the chassis side panels are
perpendicular to the ground.
Figure 9 Wall mounting
(1) Mounting hole in the switch chassis bottom
7