HP 489183-B21 - InfiniBand DDR Switch 설치 매뉴얼 - 페이지 11
{카테고리_이름} HP 489183-B21 - InfiniBand DDR Switch에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP 489183-B21 - InfiniBand DDR Switch 22 페이지. Hp blc 4x ddr infiniband gen 2 switch installation guide
HP 489183-B21 - InfiniBand DDR Switch에 대해서도 마찬가지입니다: 자주 묻는 질문 (4 페이지), 매뉴얼 사용 (15 페이지)
페이지 인쇄
2 Hardware Installation
This chapter contains the following sections:
•
Installing the HP BLc 4X DDR InfiniBand Gen 2 Switch
•
Installing InfiniBand cables in the HP BLc 4X DDR InfiniBand Gen 2 Switch
•
Cable Management
•
InfiniBand subnet managerment
2.1 Installing the HP BLc 4X DDR InfiniBand Gen 2 Switch
To install the HP BLc 4X DDR InfiniBand Gen 2 Switch, follow the steps in
Section
2.1.2.
Caution:
All panels and doors should be in place and securely fastened while the unit is in operation for
proper cooling and for EMI emissions control.
2.1.1 Prepare the Interconnect Module Bay in the HP BladeSystem c7000 Enclosure
To prepare the interconnect module bay in the HP BladeSystem c7000 enclosure, follow these
steps:
1.
Remove any devices or blanks.
2.
To remove the divider, press the divider release button (see callout 1 in
the divider out of the interconnect module bay (see callout 2 in
Figure 2-1 Removing a Divider from the HP BladeSystem c7000 Enclosure Interconnect Module Bay
The following list describes the callouts shown in
1.
Press the divider release button.
2.
Slide divider out from the interconnect module bay.
(Section
2.3)
(Section
2
1
(Section
2.4)
Figure
2-1:
2.1 Installing the HP BLc 4X DDR InfiniBand Gen 2 Switch
2.1)
(Section
2.2)
Section 2.1.1
and
Figure
2-1) and slide
Figure
2-1).
11