HP ProCurve 1600M 설치 매뉴얼 - 페이지 19

{카테고리_이름} HP ProCurve 1600M에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP ProCurve 1600M 28 페이지. Redundant power supply
HP ProCurve 1600M에 대해서도 마찬가지입니다: 사양 시트 (12 페이지), 먼저 읽기 (8 페이지), 검토자 매뉴얼 (27 페이지), 보충 설명서 (2 페이지), 보충 설명서 (2 페이지), 설치 매뉴얼 (28 페이지), 설치 매뉴얼 (36 페이지), 빠른 설정 매뉴얼 (2 페이지), 빠른 설정 매뉴얼 (4 페이지), 사용자 설명서 (8 페이지), 매뉴얼 보충 자료 (28 페이지), 먼저 읽기 (16 페이지), 설치 및 제거 (2 페이지), 설치 매뉴얼 (12 페이지), 계획 및 구현 매뉴얼 (40 페이지), 제품 수명이 다한 제품 분해 지침 (2 페이지), 설치 매뉴얼 (46 페이지), 진단 매뉴얼 (2 페이지), 분해 지침 (2 페이지)

페이지 인쇄

Troubleshooting

The primary tools for troubleshooting the switch modules are the LEDs on the

front of the switch and on the module. Refer to "LED Behavior" on page 7.

Also, refer to the Installation Guide and the Management and Configuration

Guide shipped with the switch, for more detailed troubleshooting informa-

tion.

The following tables describe switch and module LED displays that indicate

that the module or connections to the ports on the module are not operating

correctly.

Switch and Module LED Error Indicators:

Diagnostic Tips:

Tip

Number

Problem

The module is not

installed properly

in the slot or has

become partly

removed during

switch operation.

Fault

Self Test

Module Status

†

Flashing

Off

†

Flashing

†

Flashing

Off

†

The flashing behavior is an on/off cycle once every 1.6 seconds, approximately.

Under this error condition, the following events also occur:

• All the LEDs on the module stay on until the error is resolved.

• The switch software, including console and web browser access will not be

operational for approximately one minute from the time the module gets into this

condition.

Make sure to screw in the retaining screws to firmly position the module and so that

the module cannot be inadvertently pulled out by pulling on the network cables.

If this does not resolve the condition, try reinstalling the module. You can do this without

having to power down the switch.

Module Port

Link and Mode

†

Flashing

All Link and Mode LEDs On

†

Flashing

All Link and Mode LEDs On

Link and Mode LEDs On for

one or both of the ports after

a module hot swap

Link and Mode LEDs On for

one or both of the ports after

switch power on or reset

Off with cable connected

Solution

Troubleshooting

Diagnostic Tips