HP ProCurve J8766A 설치 매뉴얼 - 페이지 41
{카테고리_이름} HP ProCurve J8766A에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP ProCurve J8766A 48 페이지. Hp procurve switch vl modules
HP ProCurve J8766A에 대해서도 마찬가지입니다: 먼저 읽기 (4 페이지), 빠른 참조 매뉴얼 (44 페이지)
페이지 인쇄
Installing the Patch Cord
As shown in the illustration below, connect the patch cord to the Gigabit-LX
mini-GBIC with the section of single-mode fiber plugged in to the Tx (transmit)
port. Then, connect the other end of the patch cord to your network cabling
patch panel, or directly to the network multimode fiber.
If you connect the patch cord directly to the network cabling, you may need
to install a female-to-female adapter to allow the cables to be connected
together.
to network
multimode
cabling
the multimode cable in the patch cord
must match the characteristics of your
network cable
Figure 14. Mode Conditioning Patch Cord
Ensure you purchase a patch cord that has LC connectors on the end that
connects to the Gigabit-LX mini-GBIC, and has multimode fibers that match
the characteristics of the multimode fiber in your network.
ProCurve Switch vl Modules
Mode Conditioning Patch Cord for Gigabit-LX
Gigabit-LX port
LC Connector
single-mode section plugs into Tx
port on Gigabit-LX mini-GBIC
35