HP StorageWorks SN6000 빠른 시작 설치 지침 - 페이지 2
{카테고리_이름} HP StorageWorks SN6000에 대한 빠른 시작 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. HP StorageWorks SN6000 2 페이지. Fibre channel switch xpak stacking cable
HP StorageWorks SN6000에 대해서도 마찬가지입니다: 업데이트 매뉴얼 (9 페이지), 설치 지침 (4 페이지), 빠른 시작 설치 지침 (2 페이지)
페이지 인쇄
Install the XPAK stacking cable
1.
Use your fingers or pliers to remove one XPAK
port cover from each switch
port covers for future use.
IMPORTANT:
To maintain proper ventilation,
leave covers in place on XPAK ports that are
not being used.
Figure 1 Removing the XPAK port cover
2.
Install the XPAK stacking cable connectors with
the circuit boards toward the mid-line of each
switch faceplate
(Figure
fits one way only. When installing an 8-cm
(3-inch) XPAK stacking cable, insert the cable
connectors into the ports simultaneously.
Figure 2 Inserting the cable connectors
1
1 Connector circuit board
(Figure
1). Save the
2). The cable connector
Page 2