Diamond Tech Studio Pro Precision 2000 운영 매뉴얼 - 페이지 4

{카테고리_이름} Diamond Tech Studio Pro Precision 2000에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamond Tech Studio Pro Precision 2000 8 페이지.

C. Water Systems

The PRECISION 2000™ comes equipped with brass water supply nozzle and large capacity water bottle, offering better

water ﬂ ow to the front of the blade for increased cooling and lubrication.

1) Remove water bottle cap and ﬁ ll with approximately 24 oz. of water. Replace cap but do not screw lid on

tightly. A moderately loose lid will prevent a vacuum from occurring.

2) When ready to cut, open water valve on the bottom of the bottle by pushing the lever downward (Fig.7). Water

should begin to ﬂ ow freely from the water nozzle mounted on the blade guide assembly. Water nozzle is factory set

to ﬂ ow on the front of the blade. However, some movement may have occurred during shipment. To adjust position

of the nozzle, loosen the hex screw on the side of the blade guide assembly (Fig.8) and adjust the brass nozzle into

proper position so the water ﬂ ows to the front of the blade, retighten screw.

3) The water should drain off the work surface, through the 2 holes on the left side of the table, draining into the

lower wheel cover which acts as a reservoir.

4) The PRECISION 2000™ is equipped with a large drainage spout at the base of the saw (Fig.9). Connect tubing to

this spout and secure with locking clip. Place the open end of tube into a collection tray, bucket or sink.

WARNING: When using a Diamond Blade, never operate saw if there is insufﬁ cient water at the point of cutting, as this

will cause damage to the blade.

Fig.7

A. Blade Guide Adjustment

The PRECISION 2000™ comes with lower and upper blade guides. Correct alignment of these guides is essential to

proper glass cutting and extending blade life.

1) The blade should pass through the grooves of the upper and lower blade guides with the back edge of the blade

resting slightly inside the grooves. To adjust, use a small hex wrench and loosen the set screw located on the

right side of the lower (Fig.10) or upper blade guide assembly (Fig.11). Slide the blade guide back or forward to

achieve proper positioning. The blade should pass vertically through the guides when viewed from the side. The

PRECISION 2000™ blade guides can be rotated 3 times for extended guide wear.

NOTE: Blade guides should be inspected and adjusted after approximately 3 hours of use. Frequent replacement

of blade guides is recommended to maintain cutting accuracy and extend blade life.

B. Use of Miter Gauge for straight edge or angle cuts

1) Set guide at the desired angle by loosening thumb screw and rotating position mark on the silver bar to

desired angle.

2) Tighten screw to secure setting. Place angle guide into the channel on the work surface.

3) Place material against the straight edge guide and feed the material slowly into the blade (Fig.12) pushing back to the

guide. The band saw is designed for intricate radius cutting; however the miter gauge will permit straight edge cutting

when needed.

C. Blade Tracking

Each PRECISION 2000™ is fully tested and adjusted before it is shipped. Occasionally, additional tracking adjustments

are necessary due to movement in shipping. Ideally the blade should be positioned 1/8" - 1/16" (3.75 - 1.66 mm) from

the back wall of the upper wheel.

*Excess tubing can be cut and removed using household scissors.

Fig.8

USE AND MAINTENANCE

Fig.9