Diamondback 64683 사용 설명서 및 안전 지침 - 페이지 12

{카테고리_이름} Diamondback 64683에 대한 사용 설명서 및 안전 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamondback 64683 20 페이지. 7" heavy-duty tile saw with sliding table

페이지 인쇄

Miter adjustment

note: The Miter Gauge can be used from

either the left or the right side of the Blade.

1. Place the slot on the underside of the

Miter Gauge on the Table Fence.

2. Lock the Miter Gauge securely to the table by

turning the Gauge Lock Knob clockwise.

3. To adjust angles:

a. Loosen the Miter Lock Lever.

b. Set to the desired angle by moving

the Gauge left or right.

c. Tighten the Miter Lock Lever securely

before turning on the Saw.

Bevel adjustment

1. Slide the table clear of the Blade

to prevent blade damage.

2. Loosen the Bevel Lock Lever.

3. Adjust the Motor Head to the desired angle:

0º, 22.5º or 45º. Do not set bevel to

any other setting. The slots in the Table

are designed only for these cuts.

4. Tighten the Bevel Lock Lever.

Depth adjustment

1. Depth Lock: Use the Depth Lock to lock the

Motor Head in the down position; press it in while

the Motor Head is down to lock, and pull out

while holding down the Motor Head to unlock.

2. Depth Knob: The Depth Knob can be used to

lock the Motor Head at a particular cutting depth;

tighten it to lock the Motor Head in place,

loosen it to allow adjustment.

Page 12

For technical questions, please call 1-888-866-5797.

Miter Lock

Lever

Miter Gauge

Bevel Lock

Lever

Bevel Lock Lever

Depth Knob

Depth controls

Gauge

Lock Knob

table

Fence

Depth

Lock

Item 64683