EasyPet EP-380R 사용자 설명서 - 페이지 4

{카테고리_이름} EasyPet EP-380R에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. EasyPet EP-380R 19 페이지. Easypet rechargeable multi-dog remote training system

From Level 90 to Level 99, it has the strongest static pulse stimulation intensity again

with different correction durations (from 200ms/0.2 second to 2 seconds).

Quick Start Guide

Step 1: Prepare the Remote Transmitter Handset

The transmitter handset should normally have battery power left and you can start

using it without putting it on charge first.

To switch on the transmitter, press and hold ON button (+) on the transmitter for 3

seconds. To switch it off, please press and hold OFF button (–) for 3 seconds.

If battery status bar shows empty bar on LCD display, it means the battery is running

down and please charge the transmitter with the supplied charger plug immediately.

When the battery is low, the LCD backlight will flash three times whenever the "T"

button is pressed, to prompt the you to charge the transmitter.

into the charger port of the transmitter which is located at the bottom part of the

transmitter handset. If the transmitter handset is switched off, please turn it on

during charging. The battery status bar on LCD display will start flashing with moving

bars. When the battery status bar stops flashing with full bars showing, the

transmitter is fully charged. The normal charging time for transmitter is around 4

hours, for new battery, it will take longer to get fully charged in the first few cycles.

Please remove the power plug from the wall socket when the transmitter is fully

charged.



Plug the supplied wall charger into the wall socket and

Press and hold down the ON button

for 3 seconds to turn on the

transmitter

Press and hold down the OFF button

for 3 seconds to turn off the

transmitter

Short press T button to send out a

command to the collar receiver