EasyPet EP-380R 사용자 설명서 - 페이지 6

{카테고리_이름} EasyPet EP-380R에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. EasyPet EP-380R 19 페이지. Easypet rechargeable multi-dog remote training system

(sometimes accidentally), the collar receiver will not receive the command sent out

from the transmitter handset.

Correction Level Indicator: This indicates the level settings of the current correction

mode.

If it displays "– –" on the Correction Level Indicator (with no numbers), it means the

transmit function on the transmitter is disabled temporally: When in this "No

Transmit" mode, transmitter will NOT send out any commands even if T button

(transmit button) is pressed. This feature is to avoid the T button (transmit button)

to be pressed by accident during a walk or a training session while the transmitter is

turned on. To enter this "No Transmit" mode, simply press the current selected

correction mode button once - or press any other correction mode button twice. To

quit this "No Transmit" mode, simply press any correction mode button (button 5, 6

or 7 in the picture) once.

Correction Type Indicator: This indicates the current selected correction mode in

symbols (Lightening symbol for static pulse stimulation mode. Speaker symbol for

warning tone mode. Shaking symbol for vibration mode).

ON/OFF (+/–) Button(s): Press and hold down ON button for 3 seconds, this will turn

on the transmitter handset. Press and hold down the OFF button for 3 seconds, this

will turn off the transmitter handset.

When transmitter is ON, short press "+" or "–" button will adjust the correction level

setting on selected correction mode. When the correction level is at the lowest

setting (Level 1), short press "–" button once will change the level setting to the

highest level of the selected correction mode. When the correction level is at the

highest setting, short press "+" button once will change the level setting to the

lowest level (Level 1) of the selected correction mode.

T Button (Transmit Button): Short press this button will send out a command of the

current correction mode to the selected dog channel. The command is sent out as

soon as this button is released (but not pressed down). The green signal indicator

light on the transmitter handset will come up to indicate the command is being sent

out to the selected dog channel. This indicator light will stay on for about 2 seconds,

the transmitter handset will not take a new command during this period.

Correction Mode Buttons: These are buttons 5, 6 and 7 in the picture. Short press

any of these buttons will allow you to select the correction mode (static pulse

stimulation, warning tone, or vibration). You may short press on these buttons to

select the correction mode to be used and then press T button to send out the

command to the selected dog channel.