Axis T92A20 설치 매뉴얼 - 페이지 6

{카테고리_이름} Axis T92A20에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Axis T92A20 12 페이지. Protective housing

Page 6

Install the camera in the housing

AXIS T92A20 comes with a pre-installed 12V High PoE Splitter.

1. Loosen the 2 Phillips positioning screws to remove the holder from camera housing (fig.1).

1. The housing is shipped with 3 black plastic spacers. Use one, two or three spacers between the

camera and holder:

•

AXIS P1311 - 1 spacer

•

AXIS Q1755 - 1 spacer

•

AXIS 210/210A - 2 spacers

•

AXIS 211/211A/211M/211W - 2 spacers

•

AXIS 221/223M - 1 spacer

2. Secure the camera, spacer(s) and holder with one of the three screws (flathead) and clear

plastic spacer (fig.1).

3. Fit the slots on the holder to the positioning screws (fig.2).

•

Make sure that the camera lens is positioned more than 2mm above the heater and

that the cables are not in contact with the heater

•

Make sure that the camera is positioned so the lens is 1-2mm from the housing win-

dow.

4. Slide the holder to a suitable position and tighten the positioning screws when satisfied.

5. Proceed to "Connect power and network cables to the camera" on page 7.

FIG.1

Axis Network

Camera

Holder

Flathead screw

Positioning

screws for

holder

Rectangular

spacer(s)

Clear plastic spacer

FIG.2

Heater

positioned here

AXIS T92A20 Installation Guide