Axis T92A20 설치 매뉴얼 - 페이지 7
{카테고리_이름} Axis T92A20에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Axis T92A20 12 페이지. Protective housing
페이지 인쇄
AXIS T92A20 Installation Guide
Connect power and network cables to the camera
4
1. The pre-installed red (+) and black (GND) wires are used to power the camera (fig.3).
2. Connect the wires to the terminal connector on the Axis network camera (fig.4).
3. Connect the supplied RJ45 patch cable to the Data Out connector on the pre-installed High
PoE Splitter (fig.3).
4. Connect the RJ45 Patch cable to the network connector on the camera.
5. Proceed to "Route the cables to the housing" on page 9.
FIG.3
Note:
The camera models have different terminal connectors. Be sure to follow the correct description
for the installed camera (fig.4).
Red/black power cable
+ / GND
+
GND
PWR OUT
High PoE
DATA OUT
Splitter
PWR IN/POE IN
Housing connector board
Wire
Connector board
Red
DC Power (+)
Black
GND
Power to
camera
GND (black)
+12V DC (red)
Camera
Camera DC Power (+)
Camera (GND)
Page 7