DieHard 200.71225 운영자 매뉴얼 - 페이지 6

{카테고리_이름} DieHard 200.71225에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DieHard 200.71225 20 페이지. Microprocessor controlled, fully automatic operation battery charger with engine starter plus battery and alternator tester for 6 and 12-volt batteries
DieHard 200.71225에 대해서도 마찬가지입니다: 소유자 매뉴얼 (17 페이지)

페이지 인쇄

FOLLOw THESE STEPS wHEN BATTERY IS INSTALLEd IN VE-

HICLE

A SPARK NEAR BATTERY MAY CAUSE BATTERY EXPLOSION. TO

REdUCE RISK OF A SPARK NEAR BATTERY:

6.1

Position AC and DC cords to reduce risk of damage by hood, door, or

moving engine part.

6.2

Stay clear of fan blades, belts, pulleys, and other parts that can cause

injury to persons.

6.3

Check polarity of battery posts. POSITIVE (POS, P, +) battery post usually

has larger diameter than NEGATIVE (NEG, N,–) post.

6.4

Determine which post of battery is grounded (connected) to the chassis.

If negative post is grounded to chassis (as in most vehicles), see (6.5). If

positive post is grounded to the chassis, see (6.6).

6.5

For negative-grounded vehicle, connect POSITIVE (RED) clip from battery

charger to POSITIVE (POS, P, +) ungrounded post of battery. Connect

NEGATIVE (BLACK) clip to vehicle chassis or engine block away from

battery. Do not connect clip to carburetor, fuel lines, or sheet-metal body

parts. Connect to a heavy gauge metal part of the frame or engine block.

6.6

For positive-grounded vehicle, connect NEGATIVE (BLACK) clip from bat-

tery charger to NEGATIVE (NEG, N, –) ungrounded post of battery. Con-

nect POSITIVE (RED) clip to vehicle chassis or engine block away from

battery. Do not connect clip to carburetor, fuel lines, or sheet-metal body

parts. Connect to a heavy gauge metal part of the frame or engine block.

6.7

When disconnecting charger, turn switches to off, disconnect AC cord,

remove clip from vehicle chassis, and then remove clip from battery termi-

nal.

6.8

See OPERATING INSTRUCTIONS for length of charge information.

NEgATIVE gROUNdEd SYSTEM

•