Olympus BH2 Series 설치 매뉴얼 - 페이지 2

{카테고리_이름} Olympus BH2 Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus BH2 Series 9 페이지. Phase contrast
Olympus BH2 Series에 대해서도 마찬가지입니다: 문제 해결 및 조정 매뉴얼 (46 페이지), 완전한 분해, 청소 및 재조립 (23 페이지), 완전한 분해, 청소 및 재조립 (40 페이지), 분해, 청소 및 재조립 (45 페이지), 매뉴얼 (6 페이지)

Last update: 2021/09/23 17:15

1) Carefully slip the knife point into the inside edge of the left ﬁne focus knob end and pry out the

20mm black disk that covers the ﬁne focus knob attachment screw.

2) Remove the left ﬁne focus knob by ﬁrst removing the attachment screw using the 2.5mm hex

wrench then pulling the knob oﬀ of the ﬁne focus shaft. It will be necessary to hold the right ﬁne focus

knob while removing the screw to prevent the shaft from turning.

3) After the knob has been removed insure that the wave washer is still located on the brass clutch

assembly on the focus shaft. If the washer has stuck to the ﬁne focus knob that was removed place it

as shown on to the focus shaft.

Installing the Drive and Back plate assembly

Locate the motor drive, the back plate and the brass clutch plate.

https://asiimaging.com/docs/

oly_bh2_zdrive_installation https://asiimaging.com/docs/oly_bh2_zdrive_installation

Printed on 2021/10/12 04:32