Olympus BH2 Series Руководство по установке - Страница 2

Просмотреть онлайн или скачать pdf Руководство по установке для Микроскоп Olympus BH2 Series. Olympus BH2 Series 9 страниц. Phase contrast
Также для Olympus BH2 Series: Руководство по поиску и устранению неисправностей и настройке (46 страниц), Полная разборка, очистка и сборка (23 страниц), Полная разборка, очистка и сборка (40 страниц), Разборка, очистка и сборка (45 страниц), Руководство (6 страниц)

Last update: 2021/09/23 17:15

1) Carefully slip the knife point into the inside edge of the left ﬁne focus knob end and pry out the

20mm black disk that covers the ﬁne focus knob attachment screw.

2) Remove the left ﬁne focus knob by ﬁrst removing the attachment screw using the 2.5mm hex

wrench then pulling the knob oﬀ of the ﬁne focus shaft. It will be necessary to hold the right ﬁne focus

knob while removing the screw to prevent the shaft from turning.

3) After the knob has been removed insure that the wave washer is still located on the brass clutch

assembly on the focus shaft. If the washer has stuck to the ﬁne focus knob that was removed place it

as shown on to the focus shaft.

Installing the Drive and Back plate assembly

Locate the motor drive, the back plate and the brass clutch plate.

https://asiimaging.com/docs/

oly_bh2_zdrive_installation https://asiimaging.com/docs/oly_bh2_zdrive_installation

Printed on 2021/10/12 04:32