Olympus BH2 Series 설치 매뉴얼 - 페이지 8

{카테고리_이름} Olympus BH2 Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus BH2 Series 9 페이지. Phase contrast
Olympus BH2 Series에 대해서도 마찬가지입니다: 문제 해결 및 조정 매뉴얼 (46 페이지), 완전한 분해, 청소 및 재조립 (23 페이지), 완전한 분해, 청소 및 재조립 (40 페이지), 분해, 청소 및 재조립 (45 페이지), 매뉴얼 (6 페이지)

Last update: 2021/09/23 17:15

two adjustment screws with the 5/32 allen wrench.

Step 6 - Installing the cover & left ﬁne focus knob

Remove the two screws from the edges of the drive assembly. Locate the ASI cover plate. Place it in

position over the motor drive assembly and secure it with the screws just removed. Place the left ﬁne

focus knob over the protruding end of the drive shaft and secure it in place with the original screw

using the 2.5 mm allen wrench. Install the 20mm black disk that covers the ﬁne focus knob

attachment screw. This 20mm black disk was removed in step #1.

Connecting the motor drive to the controller and computer

Please refer to the wiring drawings and diagrams given in the manual

Tools Needed: Small slotted screw driver.

1) Locate the drive cable. Connect one end of the drive cable to the pigtail extending from the motor

drive near the microscope and the other end to mating connector on the back of the Microscope

Focus Controller, or MS-2000 unit labeled "Drive". Secure the cable to the drive by tightening the

screws at each end of the connector.

2) Locate the computer interconnect cable. Connect one end to the mating connector on the back of

the controller labeled "Serial In". Connect the other end to the appropriate serial output connector on

your computer. .

3) Plug in the power cord / power supply

This completes the steps necessary to interconnect the ASI motor drive, focus controller and

computer. Please refer to the operation section of this manual before using the unit

zdrive, olympus,

bh-2

https://asiimaging.com/docs/

oly_bh2_zdrive_installation https://asiimaging.com/docs/oly_bh2_zdrive_installation

Printed on 2021/10/12 04:32