Olympus BXFM-ILH 사용 설명서 - 페이지 4

{카테고리_이름} Olympus BXFM-ILH에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus BXFM-ILH 36 페이지. Focusing unit

IMPORTANT

The BXFM focusing unit can be used as the basis for installing modules such as reflected light illumina-

tion equipment, objectives, eyepieces and observation tube for construction of a microscope system.

The BXFM can be installed on the exclusive stand or on your microscope.

SAFETY PRECAUTIONS

Fig. 1

Fig. 2

1. Install the microscope on a sturdy, level table or bench so as not to

block the air vents on the underside of the base.

Back

2. When combing the stand (U-ST), install the BXFM so that it forms an

angle of ±30° with respect to the pillar as shown in Fig. 1.

The compact brightfield illuminator (U-KMAS) should be installed so that,

when it is seen from the front, the lamp housing is located on its right

side.

3. When carrying the BXFM, hold the stand by the bottom with one hand

as shown in Fig. 2, and hold the focusing block with the other hand.

Front

# Do not hold the BXFM by the coarse/fine adjustment knobs or lamp

housing. Otherwise, the microscope may be damaged.

4. The surface of the lamp housing @ on the rear of the microscope be-

comes very hot. When installing the microscope system, leave spaces

of more than 10 cm around the lamp housing, particularly on the top

and bottom.

Do not install the lamp housing up side down or with the side facing up.

Also do not use the microscope in a tilted attitude.

5. The TH4 power supply is air-cooled so it becomes during operation.

When installing it, leave spaces of more than around it. Also make sure

to distribute cables away from the power supply.

6. Be sure to set the main switch to "

before replacing the light source bulb. (P. 26)

7. Always use the power cord provided by Olympus. If no power cord is

provided, please select the proper power cord by referring to the chapter

"PROPER SELECTION OF THE POWER SUPPLY CORD" at the end of

this instruction manual. If the proper power cord is not used, product

safety and performance cannot be guaranteed.

8. Always ensure that the grounding terminal of the microscope and that

of the wall outlet are properly connected. If the equipment is not grounded,

Olympus can no longer warrant the electrical safety and performance of

the equipment.

" (OFF) and unplug the power cord