Olympus MX61L 조립 설명서 - 페이지 7

{카테고리_이름} Olympus MX61L에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus MX61L 49 페이지. 200mm/300mm compatible semiconductor/fpd inspection microscopes

MX61 external view, eye point and center of gravity

Eye point

(Bottom view of microscope)

(Note) The center of gravity is an approximate position when the microscope is equipped with the standard module

combination for transmitted light observation. Note that the position is variable depending on the weight of

specimen, position of the stage and other modules used.

9. To prevent toppling of the microscope system, keep the total height of the microscope below 1 meter (3.3 ft) when

attachments (including Olympus optional modules and the CCD camera prepared by the customer) are mounted.

Fig. 2

10. Each microscope has screw holes (M5, depth 10 mm) for prevention of

toppling (in the case of an earthquake or microscope imbalance) on the

side panels @ (x 2 holes) and the rear panel ² (x 2 holes). Clamp the

microscope using L-shaped clamps and these screw holes as required.

When clamping the microscope using L-shaped clamps pre-

pared by the customer, be sure to use steel bolts (strength cat-

egory 12.9) with as long as possible threaded sections (8 mm

or more is recommended).

MX61/MX61L

Unit: mm

Position of center of gravity