Olympus U-CBS 사용 설명서 - 페이지 14
{카테고리_이름} Olympus U-CBS에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus U-CBS 16 페이지. Optical microscope accessory coded function system
Olympus U-CBS에 대해서도 마찬가지입니다: 사용 설명서 (16 페이지), 사용 설명서 (16 페이지)
페이지 인쇄
Attaching the hand switch
The hand switch is provided with the magnet. Adhering the attaching plate made of iron on the microscope frame allows
you to secure the hand switch to the attaching plate. (Two attaching plates are provided with the hand switch and one of
them is for use as a spare.)
c
a
11
d
3
b
1
Attach the attaching plate b to the magnet on the bottom of the
hand switch a .
Do not remove the sheet on the adhesive surface of the attaching
TIP
plate until the attaching position is decided.
2
Decide the attaching position c easy to operate the hand switch (
part) near the right or left coarse adjustment knob.
Be careful if the hand switch is attached too close to the
TIP
coarse focusing knob, when the pre-focusing lever d is
rotated, the hand switch may contact the pre-focusing lever.
3
Clean the attaching position with a soft cloth, remove the sheet on the
adhesive surface of the attaching plate and attach the hand switch
firmly to the microscope frame.
· Since the hand switch is provided with the magnet, do not
CAUTION
let objects that are affected by magnetism come close to
the hand switch.
· Be careful, if the connector of the coded revolving
nosepiece is not connected to U-CBS, the hand switch
does not function.
If the cable for the hand switch disturbs your operation, bundle
TIP
the cable with the Velcro tape provided with the hand switch.
Coded function system