Axminster 100090 사용자 설명서 - 페이지 3

{카테고리_이름} Axminster 100090에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Axminster 100090 12 페이지. Metal cutting bandsaw

페이지 인쇄

Illustrated Parts Breakdown for the Metal Cutting Bandsaw

Quantity

Item

1 No.

Small Metal Cutting Bandsaw, with blade fitted.

2 No.

Pulleys

1 No.

Drive Belt

1 No.

Drive Belt and Pulley Cover

4 No.

Legs

4 No.

Rails

4 No.

Stretchers

1 No.

Extension Table

Pkt containing :-

Nuts, Bolts and Washers

Allen Keys

1 No. Manual

1 No. Guarantee Card

Having unpacked your machine and its accessories, please check the contents against the

equipment list "What's in the box", if there are any discrepancies, please contact Axminster

Power Tool Centre using the procedures laid down in the catalogue. Please dispose of the

packaging responsibly; much of the material is bio-degradable. The machine and its accessories

will arrive coated with heavy corrosion preventative grease and greased wax paper. These will

need to be cleaned from the machine, its components and accessories prior to it being set up

and commissioned. Use coal oil, paraffin or a proprietary degreaser to remove the barrier grease.

Be warned, it will stain if you splash it on clothing etc.; wear overalls, coverall et al., rubber

gloves are also a good idea, as is eye protection if your cleaning process tends to be a little bit

enthusiastic. After cleaning, lightly coat the exposed metal surfaces of the machine with a thin

layer of light machine oil. N.B If you used paraffin/kerosene make sure you apply this thin film

sooner rather than later.

Good Working Practices/Safety

The following suggestions will enable you to observe good working practices, keep yourself and

fellow workers safe and maintain your tools and equipment in good working order.

WARNING!!

KEEP TOOLS AND EQUIPMENT OUT OF THE REACH OF

YOUNG CHILDREN

Primary Precautions

Mains Powered Tools

These tools are supplied with a moulded 13 Amp. Plug and 3 core power cable. Before using the

tool inspect the cable and the plug to make sure that neither are damaged. If any damage is

visible have the tool inspected/repaired by a suitably qualified person. If it is necessary to replace

the plug, it is preferable to use an 'unbreakable' type that will resist damage on site. Only use a

13 Amp plug, and make sure the cable clamp is tightened securely. Fuse as required. If

extension leads are to be used, carry out the same safety checks on them, and ensure that they

are correctly rated to safely supply the current that is required for your machine. It is also good

policy to only use switched outlet supply points.

What's in the Box?

Model Number

General Instructions for 230v Machines

G4012