Axminster 100090 사용자 설명서 - 페이지 4

{카테고리_이름} Axminster 100090에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Axminster 100090 12 페이지. Metal cutting bandsaw

페이지 인쇄

General Instructions for 230v Machines (Continued)

Work Place/Environment.

The machine is not designed for sub-aqua operation, do not use when or where it is liable to get wet. If the

machine is being used outside, and it starts to rain (unusual though this would be in U.K.), cover it up or

move it into the dry. If machine has got wet; dry it off as soon as possible, with a cloth or paper towel. Do

not use 230Va.c. powered machines anywhere within a site area that is flooded or puddled, and do not trail

extension cables across wet areas. Keep the machines clean; it will enable you to more easily see any

damage that may have occurred. Clean the machine with a damp soapy cloth if needs be, do not use any

solvents or cleaners, as these may cause damage to any plastic parts or to the electrical components.

Keep the work area as uncluttered as is practical, this includes personnel as well as

material.Under no circumstances should CHILDREN be allowed in work areas.

It is good practice to leave the machine unplugged until work is about to commence, also make sure to

unplug the machine when it is not in use, or unattended. Always disconnect by pulling on the plug body and

not the cable. Once you are ready to commence work, remove all tools used in the setting operations

(if any) and carry out a final check e.g. check drills are tight in their chucks, blades & tools are sharp and

correct type and size, power cables are free and will not snag when the machine is in use etc.

Make sure you are comfortable before you start work, balanced, not reaching etc.,

If the work you are carrying out is liable to generate flying grit, dust, chips or swarf, wear the appropriate

safety clothing, goggles, gloves, masks etc., If the work operation appears to be excessively noisy, wear

ear-defenders. If you wear your hair in a long style, wearing a cap, safety helmet, hairnet, even a

sweatband, will minimise the possibility of your hair being caught up in the rotating parts of the tool,

likewise, consideration should be given to the removal of rings and wristwatches, if these are liable to be a

'snag' hazard. Consideration should also be given to non-slip footwear, etc.

Do not work with cutting tools of any description if you are tired, your attention is wandering or

you are being subjected to distraction. A deep cut, a lost fingertip or worse; is not worth it!

Do not use this machine within the designated safety areas of flammable liquid stores or in areas

where there may be volatile gases. There are very expensive, very specialised machines for

working in these areas, THIS IS NOT ONE OF THEM.

Check that blades/drills etc., are the correct type and size, are undamaged and are kept clean and sharp,

this will maintain their operating performance and lessen the loading on the machine.

Above all, OBSERVE.... make sure you know what is happening around you, and USE YOUR COMMON

SENSE.

Initial Assembly instructions

Initial Assembly

Please take some time to read the section entitled "Identification and Parts Description"

to identify the various parts of your machine so that you are familiar with the terminology

we will use to enable you to set up and operate your Bandsaw safely and correctly.

The Stand

Overview

The stand is rectangular in shape. The bandsaw sits on the stand with the front of the machine

above the narrower side of the rectangle.

Routine Maintenance (Continued)

Transition

gearbox

Bearing housing

Motor casing

OIL

Oil