Axminster 100090 사용자 설명서 - 페이지 5

{카테고리_이름} Axminster 100090에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Axminster 100090 12 페이지. Metal cutting bandsaw

페이지 인쇄

Routine Maintenance

Daily

•Keep the machine clean

•Check the saw blade for missing teeth and cracks in the fabric.

•Spray oil the metal surfaces

•Lightly oil the main rod of the vice and ease some oil into the locking lever housing.

•Check the security of the bolts holding the machine to the stand.

Monthly

•Remove the fastening bolt from the drive belt and pulley cover, open and check the

condition of the drive belt.

•Clean out the drive belt cover, bits of belt etc,etc. DO NOT USE OIL near the belts, but a

small amount can be carefully dripped on the bearing housing of the transition gearbox.

Close the cover and re-insert the bolt.

•Using an air line (and wearing goggles) blow out the motor casing.

Six Monthly

•Remove the bolts securing the transition gearbox cover and check the grease

level.Repack as necessary, replace the cover.

Initial Assembly instructions (Continued)

Assembling the stand

Locate and identify the 4 legs, the rails (A) and the

stretchers for the stand, (B) and the packet containing

the coach bolts, washers and nuts.

The rails are almost symmetrical angle strips, the rails

have 4 holes punched in one face (2 at each end) and

are slightly shorter than the corresponding stretchers.

The shorter rails have an elongated slot cut in the

middle of the top face.

The stretchers are almost asymmetric angle strips,

both the long and the short stretchers have 2 holes

punched in one face (one each end).

Identify the two longest rails and the two longest

stretchers.

Assemble the two 'long' side frames for the stand. Bolt

the components together by putting the coach bolt

through the leg, through the rail or stretcher, secure

with washers and nut. Tighten the nut only 'finger tight'

at this time. (See fig 1)

When the two side frames have been assembled, select one, turn it upside down on a flat surface

and loosely bolt the 'short side' rails and stretchers (C) in place (See fig 2); attach the other side

frame, (keep the interleaving of the top surfaces of the rails the same, i.e. if the top face of the

narrow end of the stand rail is above the top face of the long side, keep it the same on both sides

and both ends). When all the components are assembled, using the flat surface as a reference,

tighten up all the nuts. Upright the frame and stand on the floor. (See fig 3)

Fig 3

Stand

Fig 1

Fig 2