Axminster CSC500K 사용자 설명서 - 페이지 3

{카테고리_이름} Axminster CSC500K에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Axminster CSC500K 8 페이지. Key operated woodturning chuck set

Good Working Practices/Safety

The following suggestions will enable you to observe good working

practices, keep yourself and fellow workers safe and maintain your

tools and equipment in good working order.

WARNING!!

1. Do not wear gloves or loose clothing when turning.

2. Do not wrap any strip sandpaper or clothing around your hands or fingers when

sanding or turning.

3. Use proper eye protection when turning.

4. Check your wood for splits, weakness or cracking prior to mounting on the

chuck.

5. Confirm that the wood is tightly gripped before turning your chuck under power.

6. Rotate the chuck manually prior to starting your lathe to confirm proper

clearance.

7. Always check and re-lighten after any problem or catch.

8. Use appropriate speeds as referenced in instructions.

9. Always turn with sharp lathe chisels.

10. Capture fine particles from the air with a dust collector.

11. Keep clean and lubricate with a light coat of oil.

Model Number:

A CSC500K 65mm Barracuda chuck (pre-threaded for 1" x 8tpi)

B 1 Set (4 pieces) gripper jaws (shipped pre-mounted to chuck)

C 1. Hex wrench

D 1 Tightening Key

E 1 Set( 4 piece) extended pin jaws

F 1 Set (4 piece) step jaws

G 1 Set (4 piece) internal & external gripper jaws

H 1 Screw chuck

H 1 3/4" x 16tpi adaptor

Instruction Manual

Safety Instructions for Chuck Systems...

KEEP TOOLS AND EQUIPMENT OUT

OF THE REACH OF YOUNG CHILDREN

What's in the Box...

(210307) CSC500K