ARC Audio KS125.2 MINI 설치 지침 매뉴얼 - 페이지 7

{카테고리_이름} ARC Audio KS125.2 MINI에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ARC Audio KS125.2 MINI 17 페이지. Moto series

페이지 인쇄

H. Next mount the new replacement speaker onto the

rear of the plate and align the tabs on the speaker

to the mounting holes on the plate and then secure

the speakers to the plate using the (4) Factory

phillips screws you removed from the stock speak-

ers. (Please note it may be necessary to use your

cutters to trim one of the mounting tabs to allow

clearance for the tweeter on component installa-

tions.) (See Figure 6H)

I. Using the factory T35 Torx screws re-attach the

factory speaker plate to the inner fairing. Be sure

to make note of the front grill and that it is

centered in the fairing opening. (See Figure 6I)

J. For Component installation remove the external

crossovers from their packaging and set aside.

Using non-residue cleaning solovent clean the flat

surface areas below and off to the sides of the

radio in preparation to mount the crossovers. Then

using the provided adhesive backed velcro, mount

the crossovers using firm pressure to insure good

adhesion. (See Figure 6J)

K. For Component installations connect your tweet-

ers and Mids to their respected crossovers and then

connect the crossovers to the amplifier. (See

Figure 6K)

L. Place the fuse in fuse holder for amplifier (If

amplifier was installed)

M. If installing speakers only to the factory head

unit connect the factory speaker wires to the new

speakers.

N. If connecting to a ARC Audio KS125.2 Mini

Amplifier, now connect your newely installed speak-

ers directly to the speaker outputs of the ampli-

fier making sure to follow L+R Channel assignment

and polarity

O. Now test your newely installed product prior to

reinstalling the front ferring.

P. Now reinstall the front fairing onto the bike.

Reconnect the headlight plugs and any additional

electronics that may be individual to your motor-

cycle. Then carefully reposition the fairing onto

the bike making sure to lift firmly to bring the

slots in the ferring over the frame hooks to ensure

the fairing is properly secured. Then reattach the

2 lower marker lights and then screw in the (6)

factory torx screws to complete the reassembly of

your motorcycle.(be sure to not overtighten these

screws as the fairing is made of plastic and can

easily strip out the screw holes.)

For additional product infomation visit WWW.ARCAUDIO.COM

Figure 6H-

Figure 6I

Figure 6J-

Figure 6K-

Contined..........