CIPTA PERNIKA NUSANTARA SMART VMS 장치 지침 - 페이지 5

{카테고리_이름} CIPTA PERNIKA NUSANTARA SMART VMS에 대한 장치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. CIPTA PERNIKA NUSANTARA SMART VMS 6 페이지.
CIPTA PERNIKA NUSANTARA SMART VMS에 대해서도 마찬가지입니다: 매뉴얼 (3 페이지)

페이지 인쇄

NOT OK

EMI

EMI (Electromagnetic Interference) from engine components

2.2. Antenna cable installation on device

After antenna and cable installed, next is install SBD and GPS antenna(picture 4

and 5) to Armada device (picture 1). Warning: Do not connect it reverse.

2.3. Devices Placement

Device position (picture 1) that have LED facing the front (if device on table), if it's

on the wall power and cable must facing down. Make sure device position

avoid water, and SOS button easy to reach.

3. Turn on Devices

3.1. Fuse Installation on the device

Insert the fuse (Gambar 3) to the device at the fuse holder, make sure device

already got signal GPS and SBD signal corresponding in the operator manual, if

not get signal check again connection GPS and SBD cable

*Fuse installation will make POWER LED lit orange/amber

Fuse

BETTER

Device Installation

BEST

GOOD

Fuse