Creator CRT-531 Series 제품 사양 - 페이지 12
{카테고리_이름} Creator CRT-531 Series에 대한 제품 사양을 온라인으로 검색하거나 PDF를 다운로드하세요. Creator CRT-531 Series 13 페이지. Card dispenser
페이지 인쇄
SPECIFICATION
4）Use soft cloth with alcohol to clean the dirty cards and replace the distortion cards
5) Check the graduation of knob to see whether they are corresponding.
6.2 Cautions for safe use
1 ） Ensure the power connected with card dispenser is off while repairing the whole
machine.
2） Notice the cathode and anode of the machine power while power on for the first time.
3 ） Notice the Specification of JUMP when using for the first time, because improper
JUMP will cause work off or unpredictable status.
4） If you do not use insulation power, external power must not be connected to insulation
power, otherwise, PCB will be broken.
5) Prohibit to inset or pull out the receptacle of the port. Otherwise, the circuit of the
controller may be spoiled.
6） Ensure the dispenser out of smear. The smear will affect the capability of the dispenser.
7) On the back of dispenser side board, there is a red soft manual "Reset " keystoke. When
error or abnormal situation occurs on spot, then engineer can press this keystoke for reset.
It is not used in general situation.
8) Red soft "RESET" keystoke function is looked as card coordinating and card return to
pre-dispense or capture position when error occurs. Once use "RESET", Pre-dispense
will be invalid, until use "DC" and "FC".
9) "RESET" has overtime protection function, when the keystoke is pressed for a long
time, then motor will stop automatically to protect itself.
6.3 Caution for program
1）"4"is pre-dispense position, FC command will not has the function of this position.
2）In order to improve the communication speed of the program, condition inspection
will just be execute one time when "RESET"; User can "Reset" to check if the
condition is correct. (Reset by three ways: press "RESET" on PCB of dispenser
bottom, press red soft "RESET" on back of dispenser side board, or by power on/off)
3) Under RS232 mode ， sending enquiry command will cause program enter
communication interruption processing, which will affect card dispensing and other
execution, the time alternation for next enquiry command should be over 200ms.
7．WARRANTY
1) One year guarantee free of charge. Counting from the day that users receive the goods.
2) User sends the goods to us for repairing.
3) Provide after-sale service after exceeding guarantee period. We will take some material
fee if need to replace fittings. And we will take some upkeep in the follows situations
although it is in guarantee period:
a) Damage and trouble caused artificially;
b) Damage and trouble caused by non-professional operation;
c) Damage and trouble caused by instability of user's power supply;
d) Damage and trouble caused by force majeure, such as earthquake, natural weather etc.
Card Dispenser
Model No.
CRT-531
Date
2010-2-1
Ver.
Page
12/13
3.0