Axxess AX-ADFD01 설치 지침 매뉴얼 - 페이지 3

{카테고리_이름} Axxess AX-ADFD01에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Axxess AX-ADFD01 16 페이지. Data interface for ford

The following (3) wires are only for multimedia/navigation radios that require these wires.

• Connect the Blue/Pink wire to the VSS/speed sense wire.

• Connect the Green/Purple wire to the reverse wire.

• Connect the Light Green wire to the parking brake wire

• Tape off and disregard the following (4) wires, they will not be used in this application:

Green, Green/Black, Purple, Purple/Black

From the AX-ADFD01 harness to the aftermarket radio:

• Connect the Black wire to the ground wire.

• Connect the Yellow wire to the battery wire.

• If installing either an ASWC-1 or AX-LCD (both sold separately), connect the (2) Red wires

to accessory power.

• Connect the Blue wire to the power antenna wire.

• Tape off and disregard the Blue/White wire with a red connector, it will not be used in

this application.

• Connect the Green wire to the left rear positive speaker output.

• Connect the Green/Black wire to the left rear negative speaker output.

• Connect the Purple wire to the right rear positive speaker output.

• Connect the Purple/Black wire to the right rear negative output.

CONNECTIONS TO BE MADE

(CONT.)

• If the vehicle is equipped with satellite radio or SYNC, and desired to be retained, connect

the Red and White RCA jacks labeled "RSE/SYNC/SAT" to the audio AUX-IN jacks.

Note: Most Ford radios have satellite radio built into the radio, so this feature is lost if so.

• If the vehicle is equipped without SYNC, and the AUX-IN jack is desired to be retained,

connect the Red and White RCA jacks labeled "FROM 3.5" to the audio AUX-IN jacks.

• If the vehicle is equipped with a factory subwoofer, connect the White RCA jack labeled

"SUBWOOFER" to the subwoofer out jack.

• Disregard the Red RCA jack labeled "CENTER CHANNEL", it will not be used in this application.

12-pin pre-wired ASWC-1 harness:

This harness is to be used along with the optional ASWC-1 (sold separately) to retain steering

wheel audio controls. If the ASWC-1 is not being used, disregard this harness. If the ASWC-1

will be used, please refer to the ASWC-1 instructions for radio connections and programming.

Disregard the harness that comes with the ASWC-1.

DIN jack:

The DIN jack is to be used with the optional AX-LCD (sold separately) to retain satellite radio or

SYNC information.

Continue to Installing & Programming the AX-ADFD01

REV. 6/26/2018 INSTAX-ADFD01