Creda FLORIDA PLUS 설치 및 사용자 설명서 - 페이지 3
{카테고리_이름} Creda FLORIDA PLUS에 대한 설치 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Creda FLORIDA PLUS 12 페이지. Electric shower
페이지 인쇄
HOW TO INSTALL YOUR
WARNING: ALL WIRING AND INSTALLATION MUST BE
SUPERVISED BY A SUITABLY QUALIFIED PERSON.
WARNING: DO NOT INSTALL THIS SHOWER WHERE IT MAY BE
SUBJECTED TO FREEZING CONDITIONS
We recommend that the installation is done in the following sequence.
a. Fixing the shower to the wall b. Plumbing c. Electrical connections
a. FIXING THE SHOWER TO THE WALL
1. Position the riser rail at a convenient height for majority of users
as detailed in Diagram 1 and mark its position.
2. Position the heater so that the top of the unit is horizontal and
level with, or a maximum of 0.6 metres (2ft) below the
top of the riser rail.
The heater MUST BE installed on a flat surface that extends
beyond the boundary of the unit in ALL directions.
3. Adjust the position to get the most convenient arrangement taking
the following into account.
The heater must not be mounted in the direct spray of the handset.
The handset must not be able to come into contact with used water in the cubicle,
bath or basin. If it can, even after the hose has been retained by the retaining ring
(see Diagram 8 on page 9), then a vacuum breaker must be fitted.
4. Fix the riser rail with screws provided.
The fixing holes at the base of the brackets will be revealed by removing the plastic fronts.
Assemble as shown in Diagram 8 on page 9.
5. Decide the position of the electrical cable into the unit.
If top or bottom entry is chosen, cut away the walls in the backplate as shown in Diagram 2a/b.
6. Decide the position of entry of the cold water pipe into the unit.
If top, cut away the backplate.
If rear, please read the section on plumbing.
If bottom or side, remove the front cover and carefully cut away the detachable corner section
as shown in Diagram 2a, taking care to remain within the guide mark.
FLORIDA PLUS
Diagram 2a
Detachable
Corner Section
Diagram 2b
3
SHOWER
Diagram 1
Diagram 1a