Diginet RAPIX DGOZ-LLS-M 설치 매뉴얼 - 페이지 3

{카테고리_이름} Diginet RAPIX DGOZ-LLS-M에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Diginet RAPIX DGOZ-LLS-M 8 페이지. Light level sensor with three inputs for pir sensors

페이지 인쇄

RAPIX Lighting Control System

6. Possible operational setups:

• 'Daylight harvesting', where DALI luminaires connected to a RAPIX Lighting Control System are dimmed up or

down to maintain a required illuminance (Lux) level on a desktop.

• Set PIR sensor operation based on Light Level, for example: movement detected by PIR turns a RAPIX Zone on,

but only in dark; or movement detected by PIR turns a RAPIX Zone on, but only in light.

• Stepped light level response to allow different events to occur on a RAPIX Lighting Control System at different

light levels.

• Sunset/sunrise switch operation. For example light switches on at low light/night/dusk and off for sunrise

/daylight.

• Enable/disable the Light Level Sensor.

• Enable/disable PIR's connected to the Light Level Sensor.

7. Mounting the Light Level Sensor

The RAPIX Light Level Sensor can be mounted in any electrical accessory plate than accepts standard

Australian/New Zealand electrical accessory plates with a standard Australian mechanism aperture. For example,

Clipsal 2000™ or C2000™.

RAPIX Light Level Sensor can be installed into any electrical

accessory with a standard Australian plate aperture

Light Level Sensor installed in Australian wall plate

RAPIX Light Level Sensor