Cisco 3020 - Cisco Catalyst Blade Switch 설치 매뉴얼 - 페이지 13

{카테고리_이름} Cisco 3020 - Cisco Catalyst Blade Switch에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 3020 - Cisco Catalyst Blade Switch 21 페이지. Release notes for the cisco catalyst blade switch 3020 for hp, ciscoã‚â iosã‚â releaseã‚â 12.2(44)se
Cisco 3020 - Cisco Catalyst Blade Switch에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (37 페이지), 시작하기 매뉴얼 (31 페이지), 빠른 사양 (12 페이지), 릴리스 노트 (41 페이지), 릴리스 노트 (27 페이지), 릴리스 노트 (23 페이지), 릴리스 노트 (21 페이지)

페이지 인쇄
Cisco 3020 - Cisco Catalyst Blade Switch 설치 매뉴얼
Chapter 2
Switch Installation
Wait for the switch module to complete POST. It might take several minutes for the switch module to
Step 1
complete POST.
Verify that POST has completed by confirming that the system and status LEDs remain green.
Step 2
If the switch module fails POST, the system LED turns amber. If the POST fails, see the
Step 3
POST Results" section on page 3-1
Cisco Systems immediately if your switch module fails POST.
Step 4
Wait approximately 2 minutes for the switch module to get the software image from its flash memory
and begin autoinstallation.
Step 5
Using a PC that is connected to the same network segment as the blade server Onboard Administrator,
access the Onboard Administrator in a browser window.
Click Enclosure > Interconnect Bays to open the Interconnect Bay Summary window where you can
Step 6
find the assigned IP address of the switch module fa0 interface in the Management URL column. (See
Figure
Figure 2-8
Click the IP address hyperlink for the switch module from the Management URL column to open a new
Step 7
browser window. The Device Manager window for the switch module opens.
On the left side of the Device Manager GUI, click Configuration > Express Setup.
Step 8
OL-8914-02
2-8.)
HP Onboard Administrator Window
to determine a course of action. POST errors are usually fatal. Call
Cisco Catalyst Blade Switch 3020 for HP Hardware Installation Guide
Running Express Setup
"Understanding
2-13