Cisco ASR 920 series 설치 매뉴얼 - 페이지 38

{카테고리_이름} Cisco ASR 920 series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASR 920 series 42 페이지. Aggregation services router
Cisco ASR 920 series에 대해서도 마찬가지입니다: 설치 매뉴얼 (36 페이지), 시작하기 (6 페이지), 하드웨어 설치 매뉴얼 (46 페이지), 매뉴얼 (36 페이지)

페이지 인쇄

1. Connect to the 10/100/1000 Ports

Connect a Management Ethernet Cable

Table 1: EIA Console Port

Label

Step 3

Connect the DB-9 end of the console cable to the DB-9 end of the terminal.

Step 4

To communicate with the router, start a terminal emulator application, such as Microsoft Windows HyperTerminal. This

software should be configured with the following parameters:

• 9600 baud

• 8 data bits

• no parity

• 1 stop-bit

• no flow control

Connect a Management Ethernet Cable

When using the Ethernet Management port in the default mode (speed-auto and duplex-auto) the port operates

in the auto-MDI/MDI-X mode. The port automatically provides the correct signal connectivity through the

Auto-MDI/MDI-X feature. The port automatically senses a crossover or straight-through cable and adapts to

it.

However, when the Ethernet Management port is configured to a fixed speed (10, 100, or 1000 Mbps) through

command-line interface (CLI) commands, the port is forced to the MDI mode.

When in a fixed-speed configuration and MDI mode:

• Use a crossover cable to connect to an MDI port

• Use a straight-through cable to connect to an MDI-X port

Cisco ASR 920 Series Aggregation Services Router Hardware Installation Guide

Component

EIA Console port

USB-to-RJ45 adapter

Installing the Cisco ASR 920 Series Router

Label

Component

RJ-45 to DB-9 cable

Desktop or system