- ページ 38

スイッチ Cisco ASR 920 seriesのPDF 設置マニュアルをオンラインで閲覧またはダウンロードできます。Cisco ASR 920 series 42 ページ。 Aggregation services router
Cisco ASR 920 series にも：設置マニュアル (36 ページ), はじめに (6 ページ), ハードウェア・インストール・マニュアル (46 ページ), マニュアル (36 ページ)

Connect a Management Ethernet Cable

Table 1: EIA Console Port

Label

Step 3

Connect the DB-9 end of the console cable to the DB-9 end of the terminal.

Step 4

To communicate with the router, start a terminal emulator application, such as Microsoft Windows HyperTerminal. This

software should be configured with the following parameters:

• 9600 baud

• 8 data bits

• no parity

• 1 stop-bit

• no flow control

Connect a Management Ethernet Cable

When using the Ethernet Management port in the default mode (speed-auto and duplex-auto) the port operates

in the auto-MDI/MDI-X mode. The port automatically provides the correct signal connectivity through the

Auto-MDI/MDI-X feature. The port automatically senses a crossover or straight-through cable and adapts to

it.

However, when the Ethernet Management port is configured to a fixed speed (10, 100, or 1000 Mbps) through

command-line interface (CLI) commands, the port is forced to the MDI mode.

When in a fixed-speed configuration and MDI mode:

• Use a crossover cable to connect to an MDI port

• Use a straight-through cable to connect to an MDI-X port

Cisco ASR 920 Series Aggregation Services Router Hardware Installation Guide

Component

EIA Console port

USB-to-RJ45 adapter

Installing the Cisco ASR 920 Series Router

Label

Component

RJ-45 to DB-9 cable

Desktop or system