Sharp AR-M161 운영 매뉴얼 - 페이지 30
{카테고리_이름} Sharp AR-M161에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp AR-M161 35 페이지. Digital multifunctional system
Problem
Printing does not
take place
(DATA indicator is
blinking.)
Printing is slow.
The printed image
is light and
uneven.
The printed image
is dirty.
The printed image
is skewed or it
runs off the paper.
Cause and solution
There is no paper in the specified tray.
→ Load paper in the tray.
"FORCED OUTPUT OF PRINT" is disabled.
→ Add paper to the bypass tray, press the [PRINT] key on the machine
to switch to printer mode, and then select "BYPASS-TRAY". Printing
will resume.
Simultaneous use of two or more application software
programs.
→ Start printing after quitting all unused application software programs.
The paper is loaded so that printing takes place on the
back side of the paper.
→ Some types of paper have a front and a back side. If the paper is
loaded so that printing takes place on the back side, toner will not
adhere well to the paper and a good image will not be obtained.
You are using paper that is outside the specified size and
weight range.
→ Use paper within the specified range.
The paper is curled or damp.
→ Replace the paper. During periods when the machine is not used for
a long time, remove the paper from the tray and store it in a dark
place in a bag to prevent moisture absorption.
You did not set sufficient margins in the paper settings of
your application.
→ The top and bottom of the paper may be dirty if the margins are set
outside of the specified print quality area.
→ Set the margins within the specified print quality area.
The paper size set in the printer driver is not the same as
the paper size loaded in the tray.
→ Make sure that the paper size setting matches the size of the paper
loaded in the tray. If the [Fit to Page] setting is selected, make sure
that the paper size selected in the "Fit To Paper Size" drop-down list
is the same as the size of the paper loaded in the tray.
The image orientation setting in the printer driver is not
correct.
→ Click the [Paper] tab in the printer driver setup screen and make sure
the "Image Orientation" setting is correct.
Paper is not loaded properly.
→ Make sure the paper is properly loaded.
The margins are not set correctly in the application.
→ Check the paper size and margin settings in the application. Also
make sure that the print settings are correct for the paper size.
TROUBLESHOOTING
Page
Operation manual
(for general
information and
copier)
4
–
–
Operation manual
(for general
information and
copier)
Operation manual
(for general
information and
copier)
5
–
6
6
Operation manual
(for general
information and
copier)
–
29