Sharp Notevision PG-D40W3D 설정 매뉴얼 - 페이지 16

{카테고리_이름} Sharp Notevision PG-D40W3D에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp Notevision PG-D40W3D 35 페이지. True xga/wxga data projectors
Sharp Notevision PG-D40W3D에 대해서도 마찬가지입니다: 사용자 설명서 (2 페이지), 사양 시트 (2 페이지), 사양 (2 페이지), 브로셔 및 사양 (2 페이지)

페이지 인쇄
Sharp Notevision PG-D40W3D 설정 매뉴얼

Controlling the Projector via LAN

After connecting the projector to your network, enter the projector IP address in
"Address" on Internet Explorer (version 5.0 or later) using a computer on the network to
start a setup screen that will enable control of the projector via the network.
Controlling the Projector
Using Internet Explorer

(Version 5.0 or later)

Complete connections to external
equipment before starting the operation.
(See pages 21-25 of the projector's
operation manual.)
Complete the AC cord connection. (See
page 25 of the projector's operation
manual.)
Note
•
When connecting the projector to the LAN, use
a commercially available LAN cable (UTP cable,
Category 5, cross-over type). When
connecting the projector to a hub, use a
straight-through cable.
1
1
Start Internet Explorer (version 5.0
or later) on the computer.
2
2
Enter "http://" followed by the
projector IP address set by the
procedure on page
"/" in "Address", and then press
the "Enter" key.
•
When "DHCP Client" is set to "OFF" on the
projector, IP address is 192.168.150.2. If you
did not change the IP address in "3. Setting
up a Network Connection for the
Projector" (pages 14-15), enter
"http://192.168.150.2/".
3
3
A screen for controlling the
projector appears, ready for
performing various status
conditions, control, and settings.
-16
15
followed by