Shimano BR-M8000 딜러 매뉴얼 - 페이지 36

{카테고리_이름} Shimano BR-M8000에 대한 딜러 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Shimano BR-M8000 39 페이지. Hydraulic disc brake

MAINTENANCE

Replacing the brake pads

This brake system is designed to automatically adjust the clearance between the disc brake rotor and the brake pads by the piston gradually

protruding according to the wear of the brake pads; therefore, when you replace the brake pads, you need to push back the piston.

If oil adheres to the brake pads, if the brake pads are worn down to a thickness of 0.5mm, or if the brake pad presser springs are interfering with

the disc brake rotor, replace the brake pads.

BR-M8000

(A)

BR-M6000

Clean the pistons and surrounding area.

To be continued on next page

Remove the wheel from the frame, and

remove the brake pads as shown in the

illustration.

(B)

(C)

Use a flat-shaped tool to push the

pistons straight back in as far as they will

go, while being careful not to twist the

pistons.

(A)

NOTE

TECH TIPS

(A)

Brake pad

(B)

Snap ring

(C)

Split pin

(A)

Piston

NOTE

Do not push the pistons with a sharp tool.

The pistons may be damaged.