Crestron 4K DigitalMedia 3-Series 보충 설명서 - 페이지 7
{카테고리_이름} Crestron 4K DigitalMedia 3-Series에 대한 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Crestron 4K DigitalMedia 3-Series 20 페이지. Media presentation controller
Crestron 4K DigitalMedia 3-Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지), 매뉴얼에서 (2 페이지), 빠른 시작 매뉴얼 (7 페이지), 빠른 시작 (2 페이지), 빠른 시작 매뉴얼 (8 페이지), 매뉴얼에서 (2 페이지), 매뉴얼에서 (2 페이지)
페이지 인쇄
Rear Panel
The following illustration shows the rear panel of the DMPS3-4K-150-C.
DMPS3-4K-150-C Rear Panel
VGA IN 1-4: HD15 female;
Analog VGA/RGB/video inputs;
Signal Types: VGA, RGB, component, S-video, or composite;
Formats: RGBHV, RGBS, RGsB, YPbPr, Y/C, NTSC or PAL;
Input Level: 0.5 to 1.5 Vp-p with built-in DC restoration;
Input Impedance: 75 Ohms nominal;
Sync Detection: RGBHV, RGBS, RGsB, YPbPr;
Sync Input Level: 3 to 5 Vp-p;
Sync Input Impedance: 2.2k Ohms
NOTE:
an appropriate adapter (not included). However, input sync detection is not provided for
composite or S-video signal types.
AUDIO IN 1-4: 3.5 mm TRS mini phone jacks;
Unbalanced stereo line-level analog audio inputs;
Input Impedance: 32k Ohms unbalanced;
Maximum Input Level: 2.8 Vrms unbalanced
NOTE:
corresponding analog audio input is activated (AUDIO 1 for HDMI 1, AUDIO 2 for
HDMI 2, and so on). The analog audio inputs do not pass audio if the HDMI video input
resolution is higher than 1920 x 1200.
HDMI 1-4: 19-pin Type A HDMI female;
Digital video/audio inputs;
Signal Types: HDMI, DVI, or Dual-Mode DisplayPort
NOTE:
accommodate a DVI signal or Dual-Mode DisplayPort signal. The CBL-HD-DVI interface
cable is sold separately.
Supplemental Guide – DOC. 7724A
The VGA inputs can accept component, composite, and S-video signals using
If an HDMI input is selected but no digital audio signal is detected, the
The HDMI inputs require an appropriate adapter or interface cable to
DMPS3-4K-150-C: 3-Series 4K DigitalMedia Presentation System • 3
2
3
4