Actron AutoScanner OBD II Scan Tool CP9575 사용자 설명서 - 페이지 10
{카테고리_이름} Actron AutoScanner OBD II Scan Tool CP9575에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Actron AutoScanner OBD II Scan Tool CP9575 16 페이지. Autoscanner obd ii scan tool
페이지 인쇄
System Setup
System Setup allows:
• Display contrast to be changed,
• Tool information to be viewed,
• Display to be checked,
• Operation of the keypad to be checked,
• Memory of the Tool to be checked,
• Language to be changed,
• Units of measure to be changed.
State OBD Check (Emissions)
The State OBD Check function is used to display a basic status of the
vehicle's OBD system.
The State OBD Check function has the following areas:
MIL STATUS ON or OFF
Number of Codes Found
Number of Monitors OK
Number of Monitors Inc
Number of Monitors N/A
9 State OBD Check should be done with the key on engine
running (KOER) due to showing MIL status.
9 The number of codes found are only DTCs and not Pending
DTCs.
9 The number of Monitors that are either OK, INC or NA are
only Since DTCs Cleared and not This Drive Cycle.
9 Refer to Read Codes and I/M Monitors for more detailed
information about the results.
View Data
The View Data function allows real time viewing of the vehicle's
computer module's PID data. As the computer monitors the vehicle,
information is simultaneously transmitted to the Tool.
10