Siemens SIMATIC S7-200 매뉴얼 - 페이지 24
{카테고리_이름} Siemens SIMATIC S7-200에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIMATIC S7-200 35 페이지. Ethernet gateway for simatic mpi/ profibus driver
Siemens SIMATIC S7-200에 대해서도 마찬가지입니다: 매뉴얼 (30 페이지), 드라이버 매뉴얼 (28 페이지), 매뉴얼 (49 페이지), 매뉴얼 (18 페이지), 시스템 매뉴얼 (20 페이지)
페이지 인쇄
Micro Automation Set 14
3.
Remove the write protection of the
MicroBox PC 420.
Open the MS DOS prompt and enter the
following command to
•
deactivate:
ewfmgr c: -commitanddisable
•
activate:
ewfmgr c: -enable
the write mode.
4.
The following network settings have to be
applied on the used network card of the
MicroBox PC 420:
•
IP address:
•
Subnet mask: 255.255.255.0
5.
Install SIMATIC NET Edition 2005.
6.
Install WinAC 2005 RTX.
•
7.
Open the Station Configuration Editor
(
) in the task bar
•
Change the station name to
"WinAC_Station"
•
Assign slot 2 to WinLC RTX
•
Add the "IE-General" module on slot
3
8.
Open the included WinAC project
"Set14_WinAC_V2-0.zip" on your
configuration PC using STEP 7 and make
the following settings in STEP 7:
•
Set the access point in "Set PG/PC
Interface" to "S7ONLINE
TCP/IP(Auto) network controller"
V2.0
Entry ID 21062588
192.168.2.140
05/18/05
Live Demo
24/35