Siemens SINUMERIK 840D sl 시운전 매뉴얼 - 페이지 5

{카테고리_이름} Siemens SINUMERIK 840D sl에 대한 시운전 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SINUMERIK 840D sl 36 페이지. Operator panel front: op 010s
Siemens SINUMERIK 840D sl에 대해서도 마찬가지입니다: 업그레이드 지침 (4 페이지), 업그레이드 지침 (5 페이지), 운영 매뉴얼 (33 페이지), 업그레이드 지침 (3 페이지), 업그레이드 지침 (3 페이지), 시스템 매뉴얼 (44 페이지), 장비 매뉴얼 (28 페이지), 장비 매뉴얼 (48 페이지), 장비 매뉴얼 (26 페이지), 장비 매뉴얼 (28 페이지)

Fundamental safety instructions

1.1

Electric shock and danger to life due to other energy sources

Touching live components can result in death or severe injury.

● Only work on electrical devices when you are qualified for this job.

● Always observe the country-specific safety rules.

Generally, the following six steps apply when establishing safety:

1. Prepare for disconnection. Notify all those who will be affected by the procedure.

2. Isolate the drive system from the power supply and take measures to prevent it being

3. Wait until the discharge time specified on the warning labels has elapsed.

4. Check that there is no voltage between any of the power connections, and between any

5. Check whether the existing auxiliary supply circuits are de-energized.

6. Ensure that the motors cannot move.

7. Identify all other dangerous energy sources, e.g. compressed air, hydraulic systems, or

8. Check that the correct drive system is completely locked.

After you have completed the work, restore the operational readiness in the inverse sequence.

Electric shock due to connection to an unsuitable power supply

When equipment is connected to an unsuitable power supply, exposed components may

carry a hazardous voltage that might result in serious injury or death.

● Only use power supplies that provide SELV (Safety Extra Low Voltage) or PELV-

SINUMERIK Software Update Tool

Commissioning Manual, 03/2018, A5E42187770B AA

WARNING

switched back on again.

of the power connections and the protective conductor connection.

water. Switch the energy sources to a safe state.

WARNING

(Protective Extra Low Voltage) output voltages for all connections and terminals of the

electronics modules.