Siemens SIPART PS2 키트 설치 지침 - 페이지 5

{카테고리_이름} Siemens SIPART PS2에 대한 키트 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIPART PS2 9 페이지. Mounting bracket kit
Siemens SIPART PS2에 대해서도 마찬가지입니다: 설치 지침 (4 페이지), 사용 설명서 (28 페이지), 설치 지침 (4 페이지), 하드웨어 설치 매뉴얼 (30 페이지), 기술 설명 (26 페이지), 간결한 사용 설명서 (35 페이지), 설치 지침 (11 페이지)

Install the Mounting Plate and PS2 Assembly to the Actuator

1. First, use an air regulator to position actuator/valve to the mid-stroke position. This will ease with

assembly.

2. While positioning the mounting plate & PS2 assembly to the actuator, be sure the feedback pin

intersects the feedback arm and spring clip. You will need to slide down the stem block and pin

down the actuator shaft to secure mounting plate to actuator.

Be sure the feedback pin engages the feedback arm and spring clip as you assemble.

Remember you can unscrew the pin from the stem block if you need more pin length.

It may also be necessary to cut the feedback pin to length. If cutting the pin is necessary be

sure a ¼" of the pin protrudes through the feedback arm.

3. Once mounting plate & PS2 assembly is fully down on actuator, secure mounting plate to actuator

using the four M6 x 16 hex bolts and lock washers.

4. Once feedback pin is properly protruding through feedback arm, tighten pin to stem block using

the 5/16" hex nut.

5. Slide the PS2 along the four slots of the mount plate so the feedback arm exceeds 30 degrees of

rotation when the valve fully strokes. The maximum rotation is 100 degrees. To achieve the best

mechanical feedback performance, try to get as much physical rotation without exceeding 100

degrees.

6. Once rotation is achieved, secure PS2 to multi-mount plate by securing the four M6 bolts to PS2.

7. Go to the Initial PS2 Setup section on the next page.

15900-796