Siemens SIPART PS2 키트 설치 지침 - 페이지 4

{카테고리_이름} Siemens SIPART PS2에 대한 키트 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIPART PS2 9 페이지. Mounting bracket kit
Siemens SIPART PS2에 대해서도 마찬가지입니다: 설치 지침 (4 페이지), 사용 설명서 (28 페이지), 설치 지침 (4 페이지), 하드웨어 설치 매뉴얼 (30 페이지), 기술 설명 (26 페이지), 간결한 사용 설명서 (35 페이지), 설치 지침 (11 페이지)

15900-796

Install the Linear Adapter on the Positioner Input Shaft

1. Using the supplied hex wrench, screw the setscrew into the linear adapter until the tip of the

setscrew is just visible in the hole in the end of the adapter. See the drawing below, left.

2. The PS2 input shaft is shown above, right. It extends from the bottom of the positioner and is flat

on one side. Place the linear adapter on the PS2 input shaft so the setscrew can be tightened

against the flat on the input shaft. Tighten the setscrew securely.

Fasten the Mounting Bracket Plate to the PS2

Refer to figure 1 and attach the PS2 to the four mounting slots. Use the four M6 x 12 hex bolts

lockwashers and flat washers. Do not tighten at this time.

Install the Feedback Lever on the Linear Adapter (4" long arm is shown)

Fasten the feedback lever to the linear adapter using the supplied split lockwasher and nut. See

Figure 4.

Note: A 4 lever is shown.

Assembly is the same for all lever sizes.

Install Feedback Pin on the Stem Clamp

1. Thread the 5/16-18 hex nut as far as it can go- against the end of threads.

2. Insert the threaded end of the feedback pin into the stem clamp, do not tighten.

3. Loosely install the stem block and pin assembly to the actuator's shaft.

FIGURE 4 Feedback Lever and Retaining Clip Orientation

Input Shaft