Siemens SIPART PS2 설치 지침 - 페이지 5

{카테고리_이름} Siemens SIPART PS2에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIPART PS2 11 페이지. Mounting bracket kit
Siemens SIPART PS2에 대해서도 마찬가지입니다: 설치 지침 (4 페이지), 사용 설명서 (28 페이지), 설치 지침 (4 페이지), 하드웨어 설치 매뉴얼 (30 페이지), 기술 설명 (26 페이지), 간결한 사용 설명서 (35 페이지), 키트 설치 지침 (9 페이지)

Install the Linear Adapter on the Positioner Input Shaft

1. Using the supplied hex wrench, screw the setscrew into the linear adapter until the tip of the

setscrew is just visible in the hole in the end of the adapter. See the drawing below, left.

Linear Adapter

2. The PS2 input shaft is shown in above, right. It extends from the bottom of the positioner and is

flat on one side. Place the linear adapter on the PS2 input shaft so the setscrew can be tightened

against the flat on the input shaft. Tighten the setscrew securely.

Install Feedback Lever on the Linear Adapter

1. Secure feedback arm to linear adapter with the supplied split lockwasher and nut. See Figure 4.

2. Be sure spring clip wire is facing actuator during this assembly. Thus feedback pin will contact

spring clip before the pin goes through the feedback arm slot.

Install the Feedback Pin to the Actuator/Valve Stem Coupling

1. Using table 1 on page 3, use the appropriate feedback pin as per actuator model number.

2. Install 3/8" nut onto feedback pin. Thread hex nut onto the feedback pin up to the unthreaded

portion of the pin.

3. Screw the pin into the hole in the actuator coupling. Do not tighten the pin or nut at this time.

Fasten Mounting Plate to PS2

1. Using the four M6 lock washers and M6 Hex bolts, secure PS2 valve positioner to mounting

plate.

Set Screw

3/8

FIGURE 4 Feedback Lever and Retaining Clip Orientation

Input Shaft

15900-795